This rustic alternative to a traditional picture frame beautifully displays pages from a favorite story book, children’s artwork, or family photos. Just nail the molding and hobby board pieces directly to the backer board, and then glue the artwork in place.

 

Cost: $11

Time: 1 hour

Difficulty: Easy. Just cut the molding and hobby board pieces, and then nail them to the backer board.

Tape Measure

Ruler or Straightedge

Miter Saw

Pneumatic Nail Gun

(1) 1 x 12″ x 24″ Board to make the Backer Board

(1) ½” x ¾” x 6′ Molding to make the Frame

(1) ¼” x 6″ x 4′ Hobby Board to make the elevated Panels

¾ inch Finish Nails

Spray Adhesive

Wood Glue

Wood Filler

½” x ¾” Molding – 2 @ the width of the backer board (ends mitered at opposing 45-degree angles)

½” x ¾” Molding – 2 @ the length of the backer board (ends mitered at opposing 45-degree angles)

¼” x 6″ Panels – 4 @ 4 inches

Paper, Pages, or Pictures – 4 @ 3½”W x 5″H

 

Steps

 

1. Cut the Parts

 

Using a miter saw and the cut list above, cut the ½” x ¾” molding and ¼” x 6″ hobby boards to size. Lightly sand the cut edges of all the parts to remove burrs.
Nursery-Book-Frame-by-Build-Basic---Step-1-copy

www.Build-Basic.com2. Position the Panels

 

Mark a vertical line down the center of the 24-inch length of the 1×12″x24″ Backer Board. Draw horizontal lines along the board that run 2 7/8 inches from the top and bottom edges. Place two pieces of Molding on edge as shown so that they create an inch-wide spacer. Place the spacer over the centerline. Position a Panel on each side of the spacer inside the horizontal lines.
Nursery-Book-Frame-by-Build-Basic---Step-2-copy

www.Build-Basic.com

3. Install the Panels

 

Using a pneumatic nail gun and ¾ inch finish nails, nail through the Panels and into the Backer Board to hold them in place. Position the nails at least ¾ inch from the corners of each Panel to ensure they’ll be hidden by the artwork.
Nursery-Book-Frame-by-Build-Basic---Step-3-copy

www.Build-Basic.com

4. Add the Remaining Panels

 

Using the spacer, position and install the remaining Panels.
Nursery-Book-Frame-by-Build-Basic---Step-4-copy

www.Build-Basic.com

5. Position the Molding

 

Apply wood glue to the back of each stick of Molding, and then position it on the face of the Backer Board flush with its edges.
Nursery-Book-Frame-by-Build-Basic---Step-5-copy

www.Build-Basic.com

6. Secure the Molding

 

Nail through the Molding and into the Backer Board to secure it in place.
Nursery-Book-Frame-by-Build-Basic---Step-6-copy

www.Build-Basic.com

7. Add the Artwork or Pictures

 

Coat the back of each page or picture with spray adhesive. Center a page over each Panel, and then press it into place.
Nursery-Book-Frame-by-Build-Basic---Step-7-copy

www.Build-Basic.com

 

MORE BUILDING PLANS

 

One thought on “Build a Nursery Book Frame

Leave a Reply to Anonymous Cancel reply