I recently participated in a Home Depot Lumber DIY Challenge where I built a Connect-4-style yard game. The project called for some quite a few cuts with the hole saw. By the end of the project, I’d learned some tricks to get the cuts just right. Check out the step-by-step tutorial below!

 

See all Build Basic Tool Tutorals

 

Cost: None

Time: 15 Minutes

Difficulty: Moderate. This tool requires some practice, but one you get the hang of it, it’s very simple to use.

Note: This list may contain affiliate links

Drill/Driver

Hole Saw

Hole Saw Arbor – This is the drill bit that the set into the drill and the hole saw attaches to. Some hole saws come with this attached. If not, pick one up that fits your drill/driver (½-inch or 3/8-inch).

Plywood or board that’s thinner than the depth of the hole saw, so that the teeth can run all the way through the material.
None

 

Steps

 

1. Drill the Pilot Hole

 

Mark the center of the circle on the board. Because hole saws have a tendency to wander until the drill bit bites into the wood, begin by drilling a pilot hole. For pinpoint accuracy, use a brad point drill bit, which has a sharp point that can be pressed into the wood over the mark.
How to Use a Hole Saw by Build Basic - www.build-basic.com

www.Build-Basic.com2. Place the Hole Saw

 

Place the hole saw’s drill bit into the pilot hole.
How-to-Use-a-Hole-Saw-by-Build-Basic---Step-2-copy

www.Build-Basic.com

3. Make the Cut

 

Holding the drill/driver with both hands, start the drill and bring the bit up to speed. The trick is to gently plunge the bit until the hole saw scuffs the surface of the wood for a second. If you plunge too fast, the hole saw bites in too hard and binds up. Once the saw begins to cut, slowly plunge through the cut without pushing. Once the saw breaks through the opposite side, stop the drill/driver, allow the bit to stop turning, and then lift the saw out of the hole.
How-to-Use-a-Hole-Saw-by-Build-Basic---Step-3-copy

www.Build-Basic.com

4. Remove the Disc

 

Unplug the battery from the drill/driver. Insert the end of a screwdriver into a hole on the side of the saw, and then push out the disc.
How-to-Use-a-Hole-Saw-by-Build-Basic---Step-4-copy

www.Build-Basic.com

 

MORE BUILDING PLANS

7 thoughts on “How to Use a Hole Saw

  1. Tools Specialist

    Never thought that using a hole saw is that easy and simple with the help of the steps you posted here. I’m glad I’ve learned those few tricks from you for a basic laid out. Thank you so much!

    Reply

Leave a Reply to Steve s Cancel reply